- #LOCALLY ADMINISTERED MAC ADDRESS DUAL BAND WIRELESS AC 3165 FULL#
- #LOCALLY ADMINISTERED MAC ADDRESS DUAL BAND WIRELESS AC 3165 PC#
With more than 18 years of experience in the Networking Industry, our partners are Wodaplug & Quectel & Compex & Wallys communications. Like what Arshad mentioned and what is mentioned a lot in the forums is to make sure you test the band separately so you have a baseline.Welcome to 524wifi - home of best WiFi & LTE 5G & Internet over Coax & GEPON Optical networks! 0.00-10.00 sec 62.4 MBytes 52.4 Mbits/sec receiverĭo you have a baseline of what it was? I'm assuming you did an iperf test locally at that site without going over the WAN? You do want to test locally first to make sure that everything is configured properly since you did move from local to FlexConnect. local x.x.x.x port 59662 connected to x.x.x.x port 5201
local x.x.x.x port 59661 connected to x.x.x.x port 5201
local x.x.x.x port 59660 connected to x.x.x.x port 5201 local x.x.x.x port 59659 connected to x.x.x.x port 5201 local x.x.x.x port 59658 connected to x.x.x.x port 5201 local x.x.x.x port 59657 connected to x.x.x.x port 5201 local x.x.x.x port 59656 connected to x.x.x.x port 5201 local x.x.x.x port 59655 connected to x.x.x.x port 5201 local x.x.x.x port 59654 connected to x.x.x.x port 5201 local x.x.x.x port 59653 connected to x.x.x.x port 5201 Radio Signal Strength Indicator : -40 dBm Wireless LAN Network Name (SSID): xxxxxxxxx
#LOCALLY ADMINISTERED MAC ADDRESS DUAL BAND WIRELESS AC 3165 PC#
Please also see the below mentioned iperf test wherein the wireless client connected on 802.11n (iperf client) and another wired pc (acting as a wired iperf client).Īm i correct that wireless does not have any issues with relation to speed issue that customer has ? i think the wireless throughput is fine as expected, but please correct me if i am wrong.Ĭlient MAC Type : Universally Administered Address
#LOCALLY ADMINISTERED MAC ADDRESS DUAL BAND WIRELESS AC 3165 FULL#
The ap port was using full duplex and full speed, there is one switch (collapsed core) which is a stack of 4 switches, and then it connects the two WAN routers. What i did was i chose one client which connected on 802.11n and as u can see below the RSSI and SNR is pretty good. Once the change was done, user started complaining low speed test which was done on the internet using zscaler The ap's are 2800I and using flexconnect local switching now
For one of my sites, i had to de-commission the local and had the ap's flexconnected to a regional wlc which is a 9800.